1/2-person canoe kayak pack, 100 Essential
Set off on half-day adventures with friends or family thanks to this complete inflatable kayak pack for 1 or 2 people.
What are the dimensions, weight and maximum load?
Inflated size: - Length: 340 cm - Width: 103 cm Folded dimensions in bag: - Height: 67 cm - Width: 44 cm - Thickness: 30 cm Weight: 14 kg Maximum pressure: 0.1 bar (1.5 psi) Number of seats: 1Â or 2Â seats with a limit of 150Â kg (331Â lbs). Paddles: 2x 4-part paddles Pump: 1 manual pump Pack contents kayak, 2 seats, 2 paddles, pump, bag, repair kit, fins.
What is the back support like?
This kayak features an inflatable seat and a low backrest for lumbar support. The seats are positioned according to the number of paddlers. To set them up: use the markings on the floor as a guide
How to inflate and position the floor of the kayak
Inflate the floor, then one of the side tubes, then the second one to 50%. Check the positioning of the bladders, then fully inflate to a maximum pressure of 0.1 bar (1.5 PSI). Then close the valves. Do not over inflate! Do not leave the kayak inflated in direct sunlight. In the event of EXTREME HEAT, slightly deflate the kayak out of the water to avoid over-inflation, which could damage the kayak. Install the three skegs, unless using on a river with a low water level.
How to deflate and store the kayak
Rinse the kayak and leave it to dry. Deflate the kayak by opening the 3 Boston valves. Fold the lateral tubes down onto the floor. Roll starting from the opposite side to the valves to remove the air. Place the rolled-up kayak into the main compartment of the bag. Tighten using the compression strap. Zip up the bag
What should you do if your kayak has a puncture?
If a side bladder is damaged, unzip the side tube lengthways and remove the bladder. The floor can be uncovered by opening the rip-tab fastenings. - Case 1: the hole is in the side tube; you can use the repair kit to stick on a patch. - Case 2: the hole is located along a seam; contact the DECATHLON workshop service to exchange the faulty bladder (two-year warranty).
Canoeing and kayaking regulations
Is your canoe-kayak inflatable or rigid and is less than 3.50 metres? You have what is called a beach craft. You must always stay within 300Â metres of a shelter (any place on the coast where any craft or vessel and its crew can get to safety by anchoring or berthing, and set off again without assistance). Buoyancy life vests are not mandatory but strongly recommended to make it easier to get back in the boat if you fall out.
regulations for canoes/kayaks over 3.50Â metres
Your canoe/kayak is rigid or inflatable with at least 2 separate air chambers. It measures more than 3.50 metres. It is approved for sea use by the manufacturer. You can paddle up to 2Â nautical miles (approx. 3Â km) from shore. You must carry a number of items of safety equipment. You can find a list of these items via this link: https://www.itiwit.fr/reglementation-pour-faire-du-canoe-kayak
How to inflate and position the floor of the kayak
Inflate the floor, then a side tube, then the second one to 50%. Check the positioning of the chambers. Then fully inflate it to a maximum pressure of 0.1 bar (1.5 psi). Ensure the valves are properly closed. DO NOT OVER INFLATE! Do not leave the inflated kayak in direct sunlight In case of EXTREME HEAT, deflate the kayak slightly out of the water to avoid excess pressure that could damage it. Install the three skegs, unless using on a river with a low water level.
What if the kayak is pierced?
In the event of damage to one of the side chambers, open the side tube lengthways using the zip and remove the chamber. The floor can be uncovered by opening the rip-tab fastenings. Example 1: the hole is in the side tube; you can use the repair kit to stick on a patch. Example 2: the hole is located along a seam; contact the DECATHLON workshop service to exchange the faulty bladder (two-year warranty).
Go on half-day trips with this inflatable kayak pack for 1 to 2 people. Stable and easy to assemble, it offers plenty of legroom and space for all your stuff.
Glide performance
Entry-level model for your first kayaking experiences.
Stability
Side stoppers and wide inflatable board for excellent stability.
Easy assembly / dismantling
Inflation in 7 minutes to a pressure of 1.5 PSI (0.1 bar) Do not over-inflate.
Easy transport
The kayak can be transported folded in its backpack.
Set off on half-day adventures with friends or family thanks to this complete inflatable kayak pack for 1 or 2 people.
More Images
1/2-person canoe kayak pack, 100 Essential
Set off on half-day adventures with friends or family thanks to this complete inflatable kayak pack for 1 or 2 people.
What are the dimensions, weight and maximum load?
Inflated size: - Length: 340 cm - Width: 103 cm Folded dimensions in bag: - Height: 67 cm - Width: 44 cm - Thickness: 30 cm Weight: 14 kg Maximum pressure: 0.1 bar (1.5 psi) Number of seats: 1Â or 2Â seats with a limit of 150Â kg (331Â lbs). Paddles: 2x 4-part paddles Pump: 1 manual pump Pack contents kayak, 2 seats, 2 paddles, pump, bag, repair kit, fins.
What is the back support like?
This kayak features an inflatable seat and a low backrest for lumbar support. The seats are positioned according to the number of paddlers. To set them up: use the markings on the floor as a guide
How to inflate and position the floor of the kayak
Inflate the floor, then one of the side tubes, then the second one to 50%. Check the positioning of the bladders, then fully inflate to a maximum pressure of 0.1 bar (1.5 PSI). Then close the valves. Do not over inflate! Do not leave the kayak inflated in direct sunlight. In the event of EXTREME HEAT, slightly deflate the kayak out of the water to avoid over-inflation, which could damage the kayak. Install the three skegs, unless using on a river with a low water level.
How to deflate and store the kayak
Rinse the kayak and leave it to dry. Deflate the kayak by opening the 3 Boston valves. Fold the lateral tubes down onto the floor. Roll starting from the opposite side to the valves to remove the air. Place the rolled-up kayak into the main compartment of the bag. Tighten using the compression strap. Zip up the bag
What should you do if your kayak has a puncture?
If a side bladder is damaged, unzip the side tube lengthways and remove the bladder. The floor can be uncovered by opening the rip-tab fastenings. - Case 1: the hole is in the side tube; you can use the repair kit to stick on a patch. - Case 2: the hole is located along a seam; contact the DECATHLON workshop service to exchange the faulty bladder (two-year warranty).
Canoeing and kayaking regulations
Is your canoe-kayak inflatable or rigid and is less than 3.50 metres? You have what is called a beach craft. You must always stay within 300Â metres of a shelter (any place on the coast where any craft or vessel and its crew can get to safety by anchoring or berthing, and set off again without assistance). Buoyancy life vests are not mandatory but strongly recommended to make it easier to get back in the boat if you fall out.
regulations for canoes/kayaks over 3.50Â metres
Your canoe/kayak is rigid or inflatable with at least 2 separate air chambers. It measures more than 3.50 metres. It is approved for sea use by the manufacturer. You can paddle up to 2Â nautical miles (approx. 3Â km) from shore. You must carry a number of items of safety equipment. You can find a list of these items via this link: https://www.itiwit.fr/reglementation-pour-faire-du-canoe-kayak
How to inflate and position the floor of the kayak
Inflate the floor, then a side tube, then the second one to 50%. Check the positioning of the chambers. Then fully inflate it to a maximum pressure of 0.1 bar (1.5 psi). Ensure the valves are properly closed. DO NOT OVER INFLATE! Do not leave the inflated kayak in direct sunlight In case of EXTREME HEAT, deflate the kayak slightly out of the water to avoid excess pressure that could damage it. Install the three skegs, unless using on a river with a low water level.
What if the kayak is pierced?
In the event of damage to one of the side chambers, open the side tube lengthways using the zip and remove the chamber. The floor can be uncovered by opening the rip-tab fastenings. Example 1: the hole is in the side tube; you can use the repair kit to stick on a patch. Example 2: the hole is located along a seam; contact the DECATHLON workshop service to exchange the faulty bladder (two-year warranty).
Go on half-day trips with this inflatable kayak pack for 1 to 2 people. Stable and easy to assemble, it offers plenty of legroom and space for all your stuff.
Glide performance
Entry-level model for your first kayaking experiences.
Stability
Side stoppers and wide inflatable board for excellent stability.
Easy assembly / dismantling
Inflation in 7 minutes to a pressure of 1.5 PSI (0.1 bar) Do not over-inflate.
Easy transport
The kayak can be transported folded in its backpack.
Set off on half-day adventures with friends or family thanks to this complete inflatable kayak pack for 1 or 2 people.
Product Information
Product Information
Shipping & Returns
Shipping & Returns
Description
Set off on half-day adventures with friends or family thanks to this complete inflatable kayak pack for 1 or 2 people.
What are the dimensions, weight and maximum load?
Inflated size: - Length: 340 cm - Width: 103 cm Folded dimensions in bag: - Height: 67 cm - Width: 44 cm - Thickness: 30 cm Weight: 14 kg Maximum pressure: 0.1 bar (1.5 psi) Number of seats: 1Â or 2Â seats with a limit of 150Â kg (331Â lbs). Paddles: 2x 4-part paddles Pump: 1 manual pump Pack contents kayak, 2 seats, 2 paddles, pump, bag, repair kit, fins.
What is the back support like?
This kayak features an inflatable seat and a low backrest for lumbar support. The seats are positioned according to the number of paddlers. To set them up: use the markings on the floor as a guide
How to inflate and position the floor of the kayak
Inflate the floor, then one of the side tubes, then the second one to 50%. Check the positioning of the bladders, then fully inflate to a maximum pressure of 0.1 bar (1.5 PSI). Then close the valves. Do not over inflate! Do not leave the kayak inflated in direct sunlight. In the event of EXTREME HEAT, slightly deflate the kayak out of the water to avoid over-inflation, which could damage the kayak. Install the three skegs, unless using on a river with a low water level.
How to deflate and store the kayak
Rinse the kayak and leave it to dry. Deflate the kayak by opening the 3 Boston valves. Fold the lateral tubes down onto the floor. Roll starting from the opposite side to the valves to remove the air. Place the rolled-up kayak into the main compartment of the bag. Tighten using the compression strap. Zip up the bag
What should you do if your kayak has a puncture?
If a side bladder is damaged, unzip the side tube lengthways and remove the bladder. The floor can be uncovered by opening the rip-tab fastenings. - Case 1: the hole is in the side tube; you can use the repair kit to stick on a patch. - Case 2: the hole is located along a seam; contact the DECATHLON workshop service to exchange the faulty bladder (two-year warranty).
Canoeing and kayaking regulations
Is your canoe-kayak inflatable or rigid and is less than 3.50 metres? You have what is called a beach craft. You must always stay within 300Â metres of a shelter (any place on the coast where any craft or vessel and its crew can get to safety by anchoring or berthing, and set off again without assistance). Buoyancy life vests are not mandatory but strongly recommended to make it easier to get back in the boat if you fall out.
regulations for canoes/kayaks over 3.50Â metres
Your canoe/kayak is rigid or inflatable with at least 2 separate air chambers. It measures more than 3.50 metres. It is approved for sea use by the manufacturer. You can paddle up to 2Â nautical miles (approx. 3Â km) from shore. You must carry a number of items of safety equipment. You can find a list of these items via this link: https://www.itiwit.fr/reglementation-pour-faire-du-canoe-kayak
How to inflate and position the floor of the kayak
Inflate the floor, then a side tube, then the second one to 50%. Check the positioning of the chambers. Then fully inflate it to a maximum pressure of 0.1 bar (1.5 psi). Ensure the valves are properly closed. DO NOT OVER INFLATE! Do not leave the inflated kayak in direct sunlight In case of EXTREME HEAT, deflate the kayak slightly out of the water to avoid excess pressure that could damage it. Install the three skegs, unless using on a river with a low water level.
What if the kayak is pierced?
In the event of damage to one of the side chambers, open the side tube lengthways using the zip and remove the chamber. The floor can be uncovered by opening the rip-tab fastenings. Example 1: the hole is in the side tube; you can use the repair kit to stick on a patch. Example 2: the hole is located along a seam; contact the DECATHLON workshop service to exchange the faulty bladder (two-year warranty).
Go on half-day trips with this inflatable kayak pack for 1 to 2 people. Stable and easy to assemble, it offers plenty of legroom and space for all your stuff.
Glide performance
Entry-level model for your first kayaking experiences.
Stability
Side stoppers and wide inflatable board for excellent stability.
Easy assembly / dismantling
Inflation in 7 minutes to a pressure of 1.5 PSI (0.1 bar) Do not over-inflate.
Easy transport
The kayak can be transported folded in its backpack.
Set off on half-day adventures with friends or family thanks to this complete inflatable kayak pack for 1 or 2 people.
